Elitegroup J10IL User Manual download pdf (Page 4)

¾ Reorient or relocate the receiving antenna

¾ Increase the separation between the equipment and receiver

¾ Connect the equipment into an outlet on a circuit different

from that to which the receiver is connected

Consult the dealer or an experienced radio TV technician for help

This device and its antenna(s) must not be co-located or operating

in conjunction with any other antenna or transmitter.

Federal Communication Commission (FCC) Radiation

Exposure Statement

This EUT is compliance with SAR for general

population/uncontrolled exposure limits in ANSI/IEEE C95.1-1999

and had been tested in accordance with the measurement

methods and procedures specified in OET Bulletin 65 Supplement

This device complies with Part 15 of the FCC Rules. Operation is

subject to the following two conditions: (1) This device may not

cause harmful interference, and (2) this device must accept any

interference received, including interference that may cause

undesired operation.

FCC Caution: Any changes or modifications not expressly

approved by the party responsible for compliance could void the

user's authority to operate this equipment.

Notice:

Changes or modifications not expressly approved by the party

responsible for compliance could void the user’s authority to

operate the equipment. Shielded interface cables and a non-

shielded AC power cord must be used in order to comply with

emission limits.

This equipment is to be used with power supply:

40W

There is no internal power supply.

1 2 3 4 5 6 7 8 9 ... 74 75

No comments

Elitegroup J10IL User Manual Page 4